installation in still pictures Business Opportunities
<< Back
The pictures shown below are intermediate steps in the installation process. They are
intended to inspire confidence for those who think an installer like Mang Pidiong (Jinggoy
daw siya? Hanep!) is indispensable. No way! It is truly DIY. You may even do it your own
way. It's that simple.

One tip though: If your existing setup uses a metal tube connection from the supply valve
to the tank you need to replace this tube with a  flexible toilet tank hose available at
hardware stores (even at Walmart) for less than $3. Specs: 7/8" X 3/8" compression x 16" (at
least this long).
Flip open side of bolt cover with flat screw driver. Remove bolts and nuts (note that rounded side of nut faces up).
Disconnect hose connection to tank bottom. Insert tee.
Make sure O-rings are properly seated. Take care not to hit installed tip against any hard surface. It can break at the neck.
Hand tighten connections, open supply valve, check for leak. If needed tighten a quarter turn with slip-joint pliers.
Place open palm about 2 inches from tip. Slowly open knob to check spray.
Align bidet, replace seat and lid (rounded side of nut face up).